Nov 15th 2020
Looking for a torque converter for a honda 9 horse power with a riser plate chain and anything else I might need. I have a 60 tooth sprocket.
We have a torque converter for engines with 1" crankshafts.These are challenging to get mounted on your engine. The hub on the back of the mounting plate will hit the sidecover. You may have to figure out an alternate way to mount this (hanging straight down off the engine or even forward)The 9 HP… Read more
Nov 3rd 2020
I have the predator 212 and the max torque clutch when it says when the crankshaft is not drilled and tap I'm guessing it means if there's not a hole at the end of the crankshaft where the bolt lock washer, and flat washer goes into? So do I need to use the bolt lock washer, and flat washer at the end of the crankshaft if I have the set screws or would I have to use the set screws and the bolt and washer?
I have not seen a Predator 212 tha… Read more
Nov 2nd 2020
I recently purchased a tillotson carb from you guys and Iโm having trouble with it and was wondering if you could help.
196cc clone engine with stage 1
Bike worked great with jetted clone carb. When I put the tillotson carb on I couldnโt get it to run for more than about 5 seconds. Fires up but wonโt idle. When it does run for a couple of seconds, it backfires huge out of the carb shooting smoke and flames. Iโve tried changing the low and hig… Read more
Nov 1st 2020
I recently installed the stage 2 kit and would barely run. I read someoneโs question about this and the answer on your website was to install the additional jet that came in the package. So I did that and now wonโt start at all. The jet I installed has a sticker on the packaging labeled โGX390โ
I did not touch the springs yet.
I removed the original spacer and used the one in the packaging. Original was black, the one in package is bronze lo… Read more