Throttle Cable Clevis - Includes allen wrench
Thermal sleeving capable of withstanding 1100 degree Fahrenheit continuous. This non-flammable sleeve has a special weave that allows it to expand and contract over fittings. In addition, it has that old school sleeve look with modern heat shield...
ARC uses these fittings to install in the Clone's Valve Cover in order to Pulse the Fuel Pump. We sell the Valve Cover with the fitting already installed as well.
Kit contains two .1 mm shims and two .2 mm shims
Replacement Exhaust Studs and Flanged Nuts.
GX200/Clone/Predator 212 Stock Ignition Coil Bolt
Sidecover Bolt Clone / GX200 / Predator 212
Original Stock Part On / Off Switch for GX200 / Clone Engines
Fits Briggs & Stratton, Tecumseh, Honda, Honda Clone, & Predator 212cc.
(4) Bolts(8) Washers(4) Nylock Nuts
Not for the larger 8Hp and 13HP engines
Valve Cover Spacer allows roller rockers to clear Valve Cover Baffle. Tapped for pulse fitting to run fuel pumps or venting
Includes bolts, gasket, Pulse fitting, and Plug (if pulse fitting not needed)
Spacer is 0.600" thick
Header stud for Honda Clone and Predator engines
This is a much better bearing than what comes in a clone engine. Visually identical to the standard bearing, but they roll WAY better. These are not ceramic or coated or anything that would be considered illegal, they are just a higher quality bearing at...