OMB Warehouse

This valve cover breather filter is perfect for use when adding an aftermarket air filter to the Clone, Fits Honda , BSP, and Predator engines. Rubber end has a 12mm opening.

The tuner kit contains timing keys from 2 degrees to 12 degrees, in 2-degree increments, to fine-tune your engine for different conditions. One of each, 2/4/6/8/10/12 keys are included.

Intake Choke Hold Bracket Fits Predator 212cc Clone Gx160/GX200 BSP Go Kart Drift Trike

Mega jet kit for Fits Honda clone, GX160, GX200, Predator 212cc, GX340, GX390, Predator 420cc, and other engines. Includes (1) each of the following jets: .034, .035, .036, .037, .038, .039, .040, ...

If you run a remote tank or you've removed your stock gas tank on a Predator 212cc, 196cc or other 6.5HP type engine this adapter allows you to run standard 1/4" fuel line to this adapter, and then...

Air filter adapter kit for 8-16HP OHV Clone engines (1) Air Filter (1) Adapter to fit GX240, GX270, GX340, GX390 and Predator 301 & 420 (1) Choke hold bracket (1) Gasket Airflow increase is so...

New ARC Air Filter Adapter for the GX340/390 Predator 301cc 420cc. Designed for the GX340/390/Predator 301/420 stock Carburetor Accommodates 2 7/16" Air Filters (AFR175) Includes Billet Adapter,...

Jet kit for Fits Honda GX200, 196cc Clone, and Predator 212 engines. Includes a 140 emulsion tube and two jets: .036" and .037". If your engine runs poorly, or on half choke after upgrading your Air...

Upgraded air filter kit for Fits Honda GX200, GX160, 196cc Clone, Tillotson, DuroMax, PowerFist, WildCat, Ducar, and Predator 212cc engines. Includes Billet Air Filter adapter with Hardware Choke...

Air Filter 3-1/2" x 4" x 2-7/16" Fabric Straight Fabric air filter 3-1/2" x 4" 2-7/16" Inner Diameter Fits all standard 2-1/2" adapters Like all guaze type filters, this filter needs to be oiled...

This kit will fit Predator 212cc, Fits Honda GX160/GX200, Tillotson, and most Chinese 6.5HP OHV Clone engines. This contains the parts included in our performance kits that use the standard adapter...

Fits Honda /Clone/Predator 212cc Laser Cut FlangeFits Honda /Clone Laser Cut Exhaust FlangeApproximate Measurements:Center Hole ID: 1"Center to Center of Bolt Holes: 1-3/4"Laser cut from 1/4" plate

Fabric Air Filter The standard angled air filter used in most 4 cycle karting engines. 3-1/2" x 4" with a 20 degree angle. The inside diameter of the mounting flange is 2-7/16". Most OHV kart engines...