The tuner kit contains timing keys from 2 degrees to 12 degrees, in 2-degree increments, to fine-tune your engine for different conditions.
One of each, 2/4/6/8/10/12 keys are included.
Torque Wrench, 1/4" Drive, 20 to 200 Inch Lb. Great for torquing rod bolts and other small engine fasteners
Adjustable Push Rod tool for checking for proper pushrod length. Adjust from approx 1.2". Must be used with stock springs. Perfect for determining proper pushrod length and valve geometry.
This is for ONE tool, not a pair!
DO NOT RUN IN MOTOR
The best way to remove a flywheel. Just remove the nut, screw knocker on to the end of crank and smack with a hammer. No puller needed, eliminates cracked flywheels from pullers.Approx 8" long and weighs 1 lb 6 oz
(note: knocker must not be fully...
#35 Chain Breaker made to high quality standards to properly assemble and disassembly of 35 chain.
Dual pin design allows you to either shorten a chain or add links to make a longer chain.
This tester checks the integrity of the electrical ignition and magneto/coil ignition systems of lawnmowers, boat motors, motorcycles and automobiles. The tester checks both current and voltage and will indicate fouled electrodes. E-Z view LED and neon...
Kit contains 10 each of .019, .024 and .034 washers.
Crankshaft Holder Tool for 1" Cranks
This tool slides onto 1" cranks and allows you to bolt the plate to the sidecover for torquing flywheels or turning the crank when building an engine. The included 1/4" square key locks the hub to the crank. Also has...
Throttle wire bending tool.
DescriptionOHV valve spring compressor works with the Briggs engine, Honda engine, Predator, and the clone engines. It makes light work of the heavy duty dual spring sets. Multiple spring feet to cover all sizes of spring retainers.
Used for Cutting Spring Seats for dual springs and/or increasing spring installed height. For use with GX200 & 6.5 Chinese OHV engines. Will cut spring pocket OD to .960"
240 grit cylinder hone for GX200, Predator 212, 196cc Clones and most 6.5HP engines. Great for deglazing cylinder in preparation for new rings.