Small Engine Performance parts for Predator, Briggs, Honda, Box Stock 196cc & Clone Engines. Replacement parts, Stage Kits and more.
ARC Precision Chain Break for #35 chain. Made in Albany Ga. The finest chain break on the market.
RLV EXF5060 Header. 1" pipe with 2 stages to 1-5/16"
This pipe is intended for use on racing go karts. It may fit other applications
Fits Predator 212cc, Honda Clone 196cc, Box Stock Project. RLV Header Pipe
Honda GX200 / Clone / Predator 212 3rd Generation Non-Hemi, Valve Cover Gasket Does NOT fit 2009 Harbor Freight engine
Heavy rubber coated gasket that goes between the airbox or air filter adaptor and the stock carburetor
70mm Flattop Piston and Rings - Standard Bore
Note: Piston has standard (~.570) compression height.
Fits 212 Predators and 2.756" Hondas and Clones with 2.756" bores.Use ring set with top .057", 2nd .057", and oil .094"
Great with +.020 rods (always...
Offset Flywheel Key for GX200 / GX160 / Clones / Predator Offset Flywheel Key for GX200 / GX160 / Clones / Predator These keys are extremely popular and a favorite for racers using our 6619 and 6625 flywheels that want to adjust and tune timing for...
22mm Round Slide Mikuni Kit, Small Body, Gas. Low buck way of adding HP!
This carb is not a Japanese Mikuni. These are Chinese carbs produced under license from Mikuni.
22mm Mikuni Round Slide Carb
Mini-Bike pipes that exits to the left side. Great for applications where there is not enough between tire and seat for Center Pipe.Pipe is flared to 1 5/16" for use with RLV 1 5/16" Mufflers. Can also be used w/o a muffler for maximum performance and...
Dyno "CM" Modified Superbox Cam for Honda GX200, Predator 212 HEMI, or BSP Clone 6.5 with bored stock carb or tilly carb.* This cam provides .265" lift at the cam, which works out to .275" lift with the stock rockers.* Intake duration is 236 and Exhaust...
Billet Oil Fill Cap w/ o-ring
Fits ALL ARC Billet sidecovers only
This will NOT work in the following engines
Briggs and Stratton
SPARK PLUG BOOT WITH WIRE END. BOOT IS WATER TIGHT & HAS A BUILT IN RESISTOR OF 5000 OHMS.
Make sure you use a billet flywheel if you have taken the governor off of your motor!Kit includes: (1) angled air filter(1) air filter adapter(1) choke hold bracket(1) heavy rubber gasket(1) long carburetor stud(1) "140" emulsion tube(1) .036 jet(1)...