ARC Racing

The new 6689 billet flywheel from ARC Racing has an ultra low drag fin design that will greatly reduce air drag on your AKRA racing engine, while still moving enough air for cooling. Less air drag on...

2 Pack of 22Lb Valve Springs.These springs are recommended for use with the stock retainers. 22lbs @ .850"

For Modified BSP, Clone, GX200, Predator 212, and Yamaha F200. 36lbs at .850 installed height and coil bind at .450. Requires part number ARC_DJ-1046 retainer and keeper kit. May require head...

2 Pack of 26Lb "White" Springs. Use as intake spring when using stock intake valve and ARC DJ-1046 Spring retainer. Use as Heavy spring for intake and exhaust when using our stainless (DJ-1121,22 and...

1.3 ratio GX200 / Clone Billet Steel Rocker SetReplaces the stock rockers with 1.3:1 ratio billet steel rocker arms, heavy duty billet steel rocker studs, lash caps, rocker pivots, adjuster nuts, set...

New and Improved 1.3 Ratio Roller Tip Rockers for the Clone and Fits Honda GX160/200/Predatro 212 NON-Hemi Engines Precision machined from chromoly steel with hardened roller tips and shafts. Dyno...

New and Improved 1.2 Ratio Roller Tip Rockers for the Clone and Fits Honda GX160/200/Predator 212 NON-Hemi Precision machined from chromoly steel with hardened roller tips and shafts. Dyno tested to...

The Gage Black Venom Roller Rocker Arms are a high-quality component designed to enhance the performance of your engine. Fits Honda GX160/GX200, Predator 212/224 Non-Hemi, 196cc Clones, and Tillotson...

14x1.5mm Extended Starter Nut for Honda /196 Clone / Predator 212 and Yamaha, 66.5mm long

Fits Honda GX200 / Clone UT1 "thin" piston rings std.These rings are to be used with the UTI Pistons. They are thinner. lighter,and are gaining in popularity among Clone users.

GX200/Clone Dowell Pins for sidecover 8mm Hollow These pins help keep the gasket properly aligned when replacing the cover.

GX200/Clone Parts: 10mm Hollow Dowell Pin for attaching Cylinder Head

BSP Header Stud Nut

BSP Stock Head Bolt

GX200/Clone/Predator 212 Stock Ignition Coil Bolt

Header stud Fits Honda Clone and Predator engines

BSP / Clone Stock Rocker Arm

Carb float. This is a stock replacement part for Clone / GX200 engines.

Original Stock Part On / Off Switch for GX200 / Clone Engines

Standard Stock Flywheel key Fits Fits Honda GX160/200/240/270/390 Predator 196/212/301/420 196cc Clones and many other Chinese OHV engines

+.020" over Std. Piston Kit for GX200 / Clone INCLUDES:PistonRingsWrist PinCirclips

replacement intake valve for the 196cc Clone, GX200, and any engines that use a 25mm faced, 5.5mm stemmed valve

Dyno testing has shown as much as 4 tenths/HP and an average of 2 tenths/HP gain using Low Tension Ring Sets over stock OEM rings. The low tension rings are heat treated in a special controlled...