ARC Racing

6615 Drag PVL Finless Flywheel designed for the Junior Dragster Engines. It has an adjustable hub that allows timing changes at 1 degree increments in as little as 90 seconds without the use of...

This is the .002" undersized standard bearing used on the flathead Briggs. Used on a slightly worn crank. This bearing is also used on many stroker rods for other engines such as the Animal and GX200...

High Quality and Performance in a Head Gasket for Briggs 5hp Flathead Raptor Engines

PVL ignition coil 555681 has a 12,000 RPM limit! For use on Animal, World Formula, and with the ARC PVL billet flywheels. You must use the specific PVL flywheel with this coil  

Connecting Rod Bolts with Washers These bolts are 1/4-28 x 1" long 12 point. 170,000 lb tensile strength C37 Rockwell ATSM spec bolt. For use in the ARC stock length Fits Briggs 5hp flathead rods...

ARC Billet Connecting Rod, Briggs Flathead Stock Replacement ARCs Enduro SeriesCNC Machined from aircraft grade 7075 T-651 Aluminum and have been tested to an average of 12,500 rpmARC Billet...

Coil Bracket Assembly for using the small diameter 3HP style flywheels on the Raptor/5HP Briggs engines

Rod Bolt Set, 1" LG HP Torque bolts to 170 in/lbs

SFI certified billet flywheel for the Briggs 5hp flathead. 5-3/4" diameter(3hp) adjustable timing flywheel with rare earth magnets for a hotter spark. Timing set at 23 BTDC with 14 degrees...

ARC Billet Flywheels are CNC machined from 6061 T-6 aluminum. The Rare earth magnets (Neodymium) produce up to 17% more voltage at the coil. 30 degrees timing built into keyway. May require #5990...

Billet Rod ARC Enduro Series CNC Machined from aircraft grade 7075 T-651 aluminum. Our 1" Stroker Rods are designed to handle the rigors of todays high horsepower Junior Dragster and open...

Hardened billet crank gear for the Briggs 5hp Raptor flathead. 1.005" I.D

Starter Nut for Flathead 5/8 x 18 thread pitch Stubby

ARC Billet Dual Bearing Sidecover kit for Briggs RaptorBy placing two bearings side-by-side on the PTO side of the crankshaft, we reduce crankflex by up to 40%. Flex is a major cause of crankshaft...

This flywheel puller is designed for those who don't want to use the "knocker" method to remove their flywheel. Works with: ALL ARC Flywheels with Steel Adjustable Timing Hubs PVL Clone...

Crank Bearing ID .875   OD 2.048   Width  .500Excellent Quality aftermarket "Trick" ball bearings can be used with a variety of stock Briggs and aftermarket single and dual...

This Crank Gear is a must when using an ARC #6580 Crankshaft or a Briggs #555204(495645) Crank.This is the gear to use for the Animal Stroker. 1.005" I.D.

Fits ARC rods with stock stroke or stroker 1" (.9985") crankshaft journals. This is the standard bearing for "Stocker" 5 HP flathead rods. Also used in our 1" journal stroker rods for Jr. Dragsters...