Small Engine Performance parts for Predator, Briggs, Honda, Box Stock 196cc & Clone Engines. Replacement parts, Stage Kits and more.
Offset Flywheel Key for GX200 / GX160 / Clones / Predator Offset Flywheel Key for GX200 / GX160 / Clones / Predator These keys are extremely popular and a favorite for racers using our 6619 and 6625 flywheels that want to adjust and tune timing for...
22mm Round Slide Mikuni Kit, Small Body, Gas. Low buck way of adding HP!
This carb is not a Japanese Mikuni. These are Chinese carbs produced under license from Mikuni.
22mm Mikuni Round Slide Carb
Mini-Bike pipes that exits to the left side. Great for applications where there is not enough between tire and seat for Center Pipe.Pipe is flared to 1 5/16" for use with RLV 1 5/16" Mufflers. Can also be used w/o a muffler for maximum performance and...
Dyno "CM" Modified Superbox Cam for Honda GX200, Predator 212 HEMI, or BSP Clone 6.5 with bored stock carb or tilly carb.* This cam provides .265" lift at the cam, which works out to .275" lift with the stock rockers.* Intake duration is 236 and Exhaust...
Billet Oil Fill Cap w/ o-ring
Fits ALL ARC Billet sidecovers only
This will NOT work in the following engines
Briggs and Stratton
2 Pack of Heavy Duty Valve Springs for Honda GX240, GX270, GX340, & GX390.Approx 50 lbs at 1.125 installed height, 42lbs at 1.2, with 110 lb open pressure (.375 lift).
SPARK PLUG BOOT WITH WIRE END. BOOT IS WATER TIGHT & HAS A BUILT IN RESISTOR OF 5000 OHMS.
This is a stage 2 performance kit to put on any non-hemi Predator 212cc motor for a go kart.
Make sure you use a billet flywheel if you have taken the governor off of your motor!Kit includes:(1) angled air filter(1) air filter adapter(1) choke hold...
This little bracket bolts to the back of our billet air filter adapter to keep the choke lever in place. Without the stock air box, or this little device, the choke lever will pop off. This bracket requires the odd-shaped, thick, rubber-coated metal...
Make sure you use a billet flywheel if you have taken the governor off of your motor!Kit includes: (1) angled air filter(1) air filter adapter(1) choke hold bracket(1) heavy rubber gasket(1) long carburetor stud(1) "140" emulsion tube(1) .036 jet(1)...
Stock OEM intake valve seal. Clone/GX200 as well as the Predator 212 Non-Hemi Engines with 5.5mm valve stems.
Throttle Return Spring. This is the fine spring that slides over the throttle rod.
Replaces parts: Baja 165-225, Baja MB200-342, Coleman CT200U 26364/168F
HONDA GX110, GX120, GX140, GX160, GX200, Hisun 196cc, Predator 212
Baja Heat, Baja Warrior,...